Quick way to heat your oils

[gsxr750]

I thought i'd post this for people to try if you're looking for a quick way to get your injections done. I find doing it this way also heats the stopper to making it less brittle, and i've never had pieces break off in the vial, also it's easier to pass the pin through the stopper and I don't change the pin after drawing it's still plenty sharp :) Makes drawing thick oils through 25guage easy.

It's pretty simple. Microwave a cup of hot water until it's boiling. Sit your vial in the water (not underwater). Cover the cup and let it sit for a minute. The steam will warm up the rubber stopper. Take it out, swab the stopper and your injection site and you're off. You'll notice there's alot less bubbles this way too. Oil will flow nice and smooth, not alot of pressure needed, less pain.

http://img194.imageshack.us/img194/2354/inj1.jpg

http://img170.imageshack.us/img170/5312/inj2.jpg

http://img170.imageshack.us/img170/2056/inj3.jpg

[nisser]

Why are people complicating this:


1) Withdraw oil into syringe.

2) While changing the needle for a new one, turn on the hot water tap.

3) Put the syringe under hot water at a 45 degree angle with a sheathed needle pointing toward the ceiling. Leave under water for 10 seconds.

4) Inject.

[BAM]

Have never had to heat my gear for any reason.

[theboss]

Why are people complicating this:


1) Withdraw oil into syringe.

2) While changing the needle for a new one, turn on the hot water tap.

3) Put the syringe under hot water at a 45 degree angle with a sheathed needle pointing toward the ceiling. Leave under water for 10 seconds.

4) Inject.


werd !! :flagC

that other way is wack

[Mr Ontario]

Thanks for the pics :)

[faller]

Nothing wrong with posting up another way of doing things. Bit involved for me though, i just put some hot water in the sink, put the vials in and go and have my shower. Oil is nice and warm when i get out.

[BritishColumbian]

I wish I had time for that, I just do my shots in the morning while im driving to work.

[L3]

i have a designated saucer that i use to heat the water in my microwave :)

[Kiem]

Thanks for the writeup, but I just use a blowdryer.

[varking]

I wish I had time for that, I just do my shots in the morning while im driving to work.

Hahah OMG great haha

[C-money]

Thanks for the writeup, but I just use a blowdryer.

Ha i thought i was the only one! works awesome

[Gemini]

I wish I had time for that, I just do my shots in the morning while im driving to work.

hahaha!

[Beachmuscle]

I hear a electric heating pad works great too.

[gsxr750]

I guess the point I was trying to make is this way the steam heats the rubber stopper, making it less brittle (no pieces break off in the vial) and you can get away without switching pins after drawing.

[inxs4u]

21g to draw no heating 23g to pin who cares if it takes 2 minutes lol

[daande]

I put my gear in the freezer then inject it.

[inxs4u]

I put my gear in the freezer then inject it.

Really do you mix it with prestone!