Subcutaneously administered steroids

Slower, not lower absorbtion

the studies from the original post discuss concentrations

Ack - I meant slower. Lower estrogen sides from slower absorption.. I was thinking about that today.. if an IM shot of cyp or enanthate is absorbed more quickly, and peaks in the first couple of days before leveling off, do we see more aromatization in the first few days? So would a slower, steady absorption be different? hmm..

And by the way - that EO Prop has now made a red patch on my stomach that's a little sore. It's about 31 hours later.

my 1cc shots a little sore. i will keep them to 1/2cc max.

i noticed that 36 hours, pain peaks, and then subsides

interesting.

^^Very^^

1/2 cc has little pain. 1 cc is a little sore, but not bad.

Tomorrow I will try 2@ 1/4cc. I am thinking no ill-effects.

i shot 1/2cc x 2 spots yesterday prop in eo and no pain so far a little bit red though

My prop in EO shot is a red, tight blotch, slightly warm. I've now experimented with a 1/4 cc shot of enanthate in oil subQ, so I'll be able to compare. I always seem to react IM to EO, so we'll see if the oil shot is better.

Also - I realized that the slin pins can take a bigger gauge for drawing no problem - no need to backload, just draw with 22g and swap on a 29g.

my slin pins are fixed units, as I do peptides in them and do not want to lose any hormone.

They are 29 ga x 1/2" and draw just fine. Takes about a minute for 1/2cc

used to do this a lot.

the fastest way to load is to preload a bunch... don't pull off the orange cap just pull the plunger on the slin pin and load it from the back. leave a small air bubble so that you can hold the rubber bit of the plunger over the hole and let the bubble rise up to the tip. When the bubble has risen to the top, push the plunger in to seat it and evacuate the air. much faster to load and the needle hasn't been dulled on a rubber stopper. There are some tips and nuances to doing it this way [eg run the gear down the side of the barrel so you don't get an air lock when loading and warm the syringe in your waist band for a few minutes to thin the oil before injecting] but you will get pretty good at it after a few times.