loading syringe

[HeavyD]

anyknow how to accurately draw from multiple vials?

[deleteduser0001]

suck one, then suck the other, or do it in separate syringes. the .05cc you ****up won't kill you unless you are OCD

[Avitoholis]

suck one, then suck the other, or do it in separate syringes. the .05cc you ****up won't kill you unless you are OCD

agreed. but I wouldn't even bother using seperate syringes just get it as accurate as you can.

[HeavyD]

yea i have not really been to worried about it.... but i just didn't know if there was some trick that i did not know, besides getting it as close as possible.

[LIVEHARD]

anyknow how to accurately draw from multiple vials?

Never Will it be 100% exact the second on is always a bit off

oh well unless quote your ADD/OCD

[Kronis]

Just go by how far back you pull the plunger while the needle is in the liquid, not how much you see drawn.

If it goes from 1.2 to 1.7 you've drawn half a mL even if it doesn't look like it.

[HeavyD]

yea kronis that is what i do but what im getting at is if you draw 1cc of the first compound, that 1cc does not include what is in the tip and lenth of the needle, so im guessing it like 1.1-2cc of the first compound then when i draw the second back to 2cc its not actually 1cc and 1cc it would be more like 1.2cc and 0.8.

so i thought if i draw first compound to .9cc and second to 2cc it should be close to 1and1cc.

i already know the reply im going to get is you are way overthinking this, but i want to use high concentrations like T400 and a blend of 300eq-200deca per cc so if im out .2 cc thats a 100mg of gear and two shots a week that 200mg plus or minus witch i think would make a difference.

once again thankx again for all the replies this place is very good.

[Kronis]

Naw, ok here it goes like this. You pull the plunger back to 1.0 then you take it out of the bottle and take in 0.2 of air so the liquid will now all in the barrel and not in the needle. So now your plunger is at 1.2 but you've only got 1.0 of solution in there. Next you stab the next bottle and pull it back from 1.2 to 2.2 then pull in 0.2 of air. So now you're at 2.4mL but have exactly 2.0mL of solution. Then you can push out the excess air and all that but you will still have 2mL of gear.

[HeavyD]

thankx big guy

[giannos]

Wow, I just got confused reading this....

Okay, suppose I take 1cc of Test. Pull the plunger back to the 1 ml mark and pull the needle out. I have 1ml of gear, correct ? Meaning that there might only be .8ml of liquid in the barrel and .2 in the tip. ( still 1 ml ). Now if I don't pull any air in, and just insert my needle into my EQ bottle to draw another ml out and make it read 2ml in the barrel. Do I not still have 2ml's worth of gear ? 1 Test and 1 EQ ? wouldn't that original .2 in the tip still be accounted for since I never took it out with air ?

What am I missing here ? :confused:

[Kronis]

^^^

Well you should put in as much air as the liquid you're going to withdraw. 1cc air in 1cc oil out. So you're going to be pulling the liquid into the barrel anyways.

[tiramisu]

Other than insulin, close enough is good enough.