quick help

[bigtavi8]

When the vial gets down to say3mll of 10 left any tips on how to draw it. Youi cant stand it up right becasue it wont be able to take in oil because of the level. SO any tips on hoe to draw it when it gets down low. I tried putting the pin in halfway and the oil leaked out of the stopper causing waste..any help

[C-money]

ya stand it up right... pump a bunch of air into it to get a high pressure in the vial... lower the needle so just the tip is in the vial.. i can suck up every drop doing this...

[Avitoholis]

I concur ^^ with C-money

[theboss]

ditto...flip it over and suck it out...i dont think i have EVER tried to draw with it upright.

[chicken_hawk]

Yah, as mentioned, pump all 3cc's of Air into it. It doesn't make it perfect, but it sure helps.

Hawk

[RagingRandy]

If tipping it causes leaks, use a 1.5" pin to draw. It will reach the bottom. I keep a few around for this purpose.

[_Ragnar_]

Are you using an 18g to draw. If you arnt it will get the oil out faster, so less leakage.

[ironwill]

ya stand it up right... pump a bunch of air into it to get a high pressure in the vial... lower the needle so just the tip is in the vial.. i can suck up every drop doing this...

ditto.....

[Ritch]

I tilted my vials to the side and pretty much got every last drop out of the vials. My shoulders got tired from holding the vials up but I`d say it`s worth the effort.

[nitrous]

ya stand it up right... pump a bunch of air into it to get a high pressure in the vial... lower the needle so just the tip is in the vial.. i can suck up every drop doing this...

same here

[Big D]

if its leaking when your tipping it, you might have to much pressure in the vial take some air out and try it again. when your tipping it make sure its straight upside down, dont pry the needle sideways

[Repmeister]

I take the rubber stopper off and stick the pin right down in with the vial leaning slightly to one side.