Tren Ace Homebrew Question.

[HardWood]

I'd like to make a batch of tren ace homebrew from powder.
ba 2% bb 20%.

My question is should i make it at 75mg/ml or 100mg/ml?

I ask from a post injection pain standpoint.

Anybody notice a difference in pain between the two concentrations?

I've run tren ace b4 but it was ug produced and I had no pain issues.
Just wondering if I bump it up to 100mg/ml will there be post inject pain?

Thanks!:cflag

[Praetorian]

Painless 100mg/ml Tren acetate
5% BA
5% BB
Grapeseed oil
P

[Drummer]

5% BA 15% BB at 100mg in cottonseed was good for me.

~D~

[HardWood]

Praetorian, totally trust your advice from reading many, many of your posts.

I'm new to homebrew production so please forgive my ignorance but i have spent many hours reading and studying this and many other topics so....

5% ba sounds high and 5% bb sounds low.

I have been led to belive that higher concentrations of ba leads to more post IM injection pain?
Also I've been led to belive that higher concentrations of bb leeds to less post IM injection pain?

Dont i have to use higher than 5% concentrations of bb to get tren ace to hold in solution?

I appriciate your advice in this matter.
Thanks Preat!

[HoliTheCat]

Praetorian, totally trust your advice from reading many, many of your posts.

I'm new to homebrew production so please forgive my ignorance but i have spent many hours reading and studying this and many other topics so....

5% ba sounds high and 5% bb sounds low.

I have been led to belive that higher concentrations of ba leads to more post IM injection pain?
Also I've been led to belive that higher concentrations of bb leeds to less post IM injection pain?

Dont i have to use higher than 5% concentrations of bb to get tren ace to hold in solution?

I appriciate your advice in this matter.
Thanks Preat!

Nope you do not have to use anything other the 5% and 5%. I speak from Homebrew Experience. I personally always use 5% BA and if you want you could go up to 10% or 15% BB, but, you do not have too.

And I would make it at 100mg/ml.

As long as your powder is fairly pure, it will hold @ 5% with no issues.

[HardWood]

Excellent...thanks!
:D

[tiramisu]

I've been using 2 and 20 for my tren. I will try 5/5 next time round. Less solvents and no pain has got to be a good thing.

[canadianmuscle0803]

5% is too high if you ask me..

never had issues with 2/15 when i made mine.. making it 100mg/ml wont be an issue at all. i would mix 50% EO and 50% almond oil for the solution.. :bd

[tiramisu]

.... but if 5% ba means that you can go 5% bb then the total solvents used drops 7% in your case and 10% in mine. Less plastic melting solvents still seem like a good thing. Why would 17% solvent be better than 10% solvent?