HGC Dosing help

[Dragon1911]

Hey guys,

As im getting older i would like to start addin HCG to my cycles i understand that 250-500 iu every 2-3 days is recommended but this is where i get a bit confused.

I just want to make sure my math is right as i have never used HCG before.

If i get 5000iu and add 1ml of bac water to it i have 5000iu/ml

Now using a slin pin with 1cc 100 units i would draw to 1/2 the 10 mark or 5 units to get 250iu, is this correct?

Sorry if this is a stupid question but better safe than sorry.

[gustavo77]

Here is what i do.....i add 1ml of water to the HCG vial, mix it and draw it up and inject it into a sterile/unused vial...next i add another 1.5ml of water to the solution/vial. This gives me a solution which is 2.5ml/5000iu or 0.5ml/1000iu...so to get a 500iu dose, all i need to do is draw 25 units or 0.25ml/cc on a 1ml/100unit slin pin....

[daande]

Since you are older I would run 500iu E3D. However, I think after reading some research it would be more beneficial to use HCG the day after your last shot..Crank 10,000iu within 2 weeks.

[declan]

Somebody should sticky HCG Protocols and Reconstituting instructions for begginers, it would immensely help in the long run. Mods, Vets?

[Dragon1911]

thanks for the help guys.

Ill run 250 every 2 days and up it if needed.
Im 30 right now so im not ancient yet just want to start this now and make it routine for my cycles moving forward.

[Dragon1911]

Somebody should sticky HCG Protocols and Reconstituting instructions for begginers, it would immensely help in the long run. Mods, Vets?

I agree ive read many different protocols some run during cycle, some after cycle before PCT.

Some front load heavy and taper off, some run evenly.

Aftr reading up i was going to front load after cycle and taper off into PCT then read somewhere that heavy dosing could damage the leydig cells.

[wan2lrn]

Here is what i do.....i add 1ml of water to the HCG vial, mix it and draw it up and inject it into a sterile/unused vial...next i add another 1.5ml of water to the solution/vial. This gives me a solution which is 2.5ml/5000iu or 0.5ml/1000iu...so to get a 500iu dose, all i need to do is draw 25 units or 0.25ml/cc on a 1ml/100unit slin pin....

Is there any problem with leaving it in the HCG vial after reconstitution and NOT transferring it to an unused vial?

[Seth]

The vials tend to be a little on the small side. They barely fit 2ml. Personally I just leave it in anyways, you just have to be more precise. Also with smaller volumes, the ratio that will be wasted in the needle gets higher

[gustavo77]

Is there any problem with leaving it in the HCG vial after reconstitution and NOT transferring it to an unused vial?

Depends what brand of HCG you are using...i guess i should have been more clear with the instructions above...they were for Organon HCG which comes in a small amp like HG test does....so you need to either transfer it once mixed or store it in pre-loaded slin pins....when it comes to vet or chinese GH, where the peptide is in a sterile, multi-use vial, there is no reason to transfer anything...just add B. water, refrigerate and draw what's needed, when it's needed.